See today’s confirmed same-day availability, or text (469) 253-2403 for instant pricing
Fill Dirt Near Me

What Is a Detention Pond? Detention vs Retention, Explained

Updated November 2026

A detention pond is a basin that temporarily holds stormwater runoff and releases it slowly through a restricted outlet, so peak flow leaving a developed site is no higher than it was before development. It is dry most of the time. A retention pond (also known as a wet pond) holds a permanent pool of water and releases only what rises above that pool.

Why Do Developments Need Detention Ponds?

When a site is developed, roofs, parking lots, streets and compacted ground replace soil and grass that used to soak up rain. That impervious cover sends more water downstream, faster. Without control, the peak flow from each new development stacks on the last one and floods creeks, streets and neighbors downstream. A detention pond catches the extra runoff during a storm and lets it out at a controlled rate, usually designed so the post-development peak discharge does not exceed the pre-development peak for the design storms the local criteria specify.

Detention Pond vs Retention Pond

FeatureDetention pondRetention pond
Water most of the timeDry (or nearly dry)Permanent pool
Main purposeReduce peak flow rate downstreamStore water, settle out pollutants, sometimes an amenity
OutletLow-level restricted outlet that drains the basinOutlet set above the permanent pool
Typical settingCommercial sites, subdivisions, schoolsSubdivision amenity lakes, larger developments
Space neededBasin sized for the storm volumePool volume plus storm volume above it
Common maintenanceMowing, clearing outlets, removing sedimentShoreline and vegetation control, sediment, water quality

You will also see underground detention (pipes or vaults under a parking lot) on sites without room for an open basin, and parking lot detention where curbs pond shallow water for short periods. They do the same job with different hardware.

When Is a Detention Pond Required in North Texas?

There is no single statewide trigger. Requirements come from each city's or county's drainage criteria. In general, detention is required when a development increases impervious cover enough to raise peak runoff, and the downstream system cannot take the increase. Commercial sites, multifamily, and subdivisions are the usual cases; a single house on a large lot often is not, though some jurisdictions have rules for that too.

Across the Dallas-Fort Worth region, many cities have adopted the integrated Stormwater Management (iSWM) criteria developed through the North Central Texas Council of Governments, which set a framework for flood control, streambank protection and water quality. Others use their own drainage design manuals. Either way, the civil engineer runs the hydrology for the site, sizes the pond and outlet, and gets the design approved by the city or county before construction.

What Does a Detention Pond Look Like?

  • Basin: a graded bowl with side slopes gentle enough to mow and maintain, set by the plans.
  • Outlet structure: a concrete box, pipe or weir sized to release water at the approved rate.
  • Emergency spillway: a reinforced overflow for storms larger than the design storm.
  • Embankment: where the pond is partly above grade, a compacted earthen berm built to the plan's spec.
  • Low-flow channel: often a concrete pilot channel so the bottom drains and stays mowable.

How Is a Detention Pond Built?

A detention pond is built to the engineer's approved plans, and the city inspects it. A typical sequence:

  1. Erosion controls go in first (silt fence, construction entrance, inlet protection).
  2. The pond is cleared, stripped and excavated to the plan's bottom elevation and side slopes.
  3. Outlet pipes and structures are trenched and set to plan grades; concrete work is done by the trades the plans require.
  4. Any embankment is built in compacted lifts to the density the engineer specifies, with testing as required.
  5. Slopes are finish graded, then seeded or sodded for stabilization.
  6. The engineer or surveyor verifies volume and elevations (often an as-built survey) before the city accepts it.

A useful side effect: pond excavation often produces the fill a site needs for its building pads and grading. Balancing the two on one site cuts both import and export. See building pads and general earthmoving.

Who Maintains a Detention Pond?

Usually the property owner or the homeowners association, under a maintenance agreement or plat note the city requires. Typical upkeep is mowing, clearing trash and debris from the outlet, removing sediment when it builds up, and repairing erosion on slopes. A clogged outlet is the most common failure: the pond holds water too long or overtops.

Do Detention Ponds Need Fill or Haul-Off?

Both, depending on the site. A pond cut on a site that has no use for the dirt means export; a pond on a site that needs pads and berms may balance perfectly. When there is a gap, we haul out clean spoil and route it to nearby jobs, or deliver fill dirt and select fill where the site is short. Size material with the cubic yard calculator. If the problem is a single yard or lot that holds water rather than a development-scale requirement, see drainage solutions.

Detention Pond Construction in DFW

We excavate and build detention and retention ponds to the approved civil plans. We do not design them; your engineer sizes the pond and outlet. Each job is quoted per job: upload the civil plans through the bid form on our detention ponds page. Questions? Text (469) 253-2403.

Need Fill Dirt Delivered?

Text us your project details for a quote in minutes.

Text for Instant Quote

Frequently Asked Questions

A detention pond holds stormwater temporarily and releases it slowly, so it is dry most of the time. A retention pond keeps a permanent pool of water and releases only the water that rises above it.

Development adds impervious cover that sends more runoff downstream, faster. Detention ponds hold that extra runoff and release it at a controlled rate so downstream flooding does not get worse.

Many DFW-area cities have adopted the integrated Stormwater Management (iSWM) criteria from the North Central Texas Council of Governments, while others use their own drainage manuals. The city or county where the site is located decides which criteria apply.

A licensed civil engineer runs the hydrology, sizes the pond and outlet, and gets the plans approved. Contractors build the pond to those approved plans.

No. A properly working detention pond drains after a storm. Standing water for days usually means a clogged outlet or a bottom that was not graded to drain.

Your project starts with
the right dirt.

Text us what you need. Quoted in minutes. Delivered in hours.

Text for instant quote

Mon–Sat 7am–5pm · Responses in minutes